Rancang Bangun Alat Penyapu Lantai Semi Mekanik untuk Kampus Universitas Muhammadiyah (UM) Sumbar

Firman Sandhy; Armila Armila; Rudi Kurniawan Arief

doi:10.30630/jtm.15.2.854

Firman Sandhy Universitas Muhammadiyah Sumatera Barat
Armila Armila Teknik Mesin, Universitas Muhammadiyah Sumatera Barat
Rudi Kurniawan Arief Teknik Mesin, Universitas Muhammadiyah Sumatera Barat

DOI: https://doi.org/10.30630/jtm.15.2.854

Keywords: MOP, Engineering design, Semi Mechanical, Floor sweeper

Abstract

Sweeping the floor is not a hard job, sweeping activities will be hard and take up a lot of time if the area to be worked on is very large like in UM-West Sumatra. To simplify and save time, it is necessary to innovate a floor sweeper. The push system floor sweeper is a form of innovation that facilitates the process of sweeping the floor. In this study a thrust system floor sweeper was designed and manufactured. The design process begins with identification of needs, concept design, design and analysis using the fabrication method, then this tool is tested in a room of 35.28 meters, 61.2 meters and 122.4 meters. From the trials conducted, it was found that the floor sweeper functions properly and can clean large and spacious rooms with 50% efficiency. Thus it can be concluded that a floor sweeper can simplify the process of sweeping the floor by 50% compared to an ordinary broom.

References

M. Y. Kua et al., Teori Dan Aplikasi. Aceh, 2021.

Walker and R. Halliday, Fisika Dasar: Jakarta. Erlangga, 2010.

Munasir, Energi Kinetik dan Energi Potensial. Jakarta: Bagian Proyek Pengembangan Kuri Kulum Di Rektorat Pendi Di Kan Menengah Kejuruan Di Rektorat Jenderal PendidiKan Dasar Dan Menegah Departemen PendidiKan Nasional, 2004.

A. Nasution, Buku Ajar Statika Struktur. Medan: Universitas Medan Area Bekerjasama Dengan Pemerintah Propinsi Sumatera Utara Dinas Peindidikan Subdis Pendidikan Tinggi, 2009.

Ma’ruf, Diktat Kuliah Statika Struktur. Banjarmasin: Universitas Lambung Mangkurat, 2016.

M. A. Wahid and F. Rahmadhani, “Eksperimen Menghitung Momen Inersia dalam Pesawat Atwood Menggunakan Katrol dengan Penambahan Massa Beban,” J. Phi; J. Pendidik. Fis. dan Terap., vol. 2, no. 2, pp. 1–7, 2019.

R. Wahab, S. Tangkuman, and T. Arungpadang, “Analisis Kelelahan Axle Shaft Truk Isuzu Elf 125 Ps,” Tek. Mesin, vol. 6, pp. 1–5, 2017.

C. Salmon and J. E. Johnson, Struktur Baja: Disain dan Perilaku. Jakarta: Erlangga, 1997.

Balasubramanian, V., Varahamoorthy, R., Ramachandran, C. S., & Muralidharan, C. (2009). Selection of welding process for hardfacing on carbon steels based on quantitative and qualitative factors. The International Journal of Advanced Manufacturing Technology, 40(9), 887-897.